Going to give the fixed-wing genre another shot after my earlier attempts ended somewhat unceremoniously with a lot of pieces of broken styrofoam. My dreams are still intact (as are the electronic bits), fortunately!
I was given permission to fly over* my town’s annual July Fourth parade by the parade organizers. A local shopkeeper gave me permission to use his building’s roof as a base of operations so I could avoid the complications of taking off and landing around people. I should say that I observed myriad safety precautions (extensive preflight, route testing, LoS flying only, separate camera op, many safe landing zones ID’d) to get these.
My X8 octo performed flawlessly, and the crowd that gathered around us after I brought the copter down from the rooftop kept me there for 1.5 hours peppering me with questions (all curious, polite and positive).
Colin Snow (who was camera op’ing for me) and I had to climb two ladders (basically fire escapes) with eight 10000mAh LiPos, my ground station, and other paraphernalia. I was trying to figure out how to get the copter up onto the roof, but I realized the easiest way was to fly it up there. I resisted the temptation to have it fly my gear up there, too, but maybe I’ll try that next time! 😎
Getting it down was harder…it’s tricky to land on the ground 35’ or so below where you’re standing! So I did it in two stages by landing on the lower roof first, climbing down to that roof, then landing down in the parking lot (with Colin forming a human barricade).
Shot 30+ minutes of video on the GH4, and it’s awesome. What a day! Here are some screen caps from the video, including one that shows where we were standing.
* I should clarify that of the 30+ minutes in the air, I was only “over” the crowd for less than one minute (as I was flying across the street). I was careful to remain over rooftops and trees the entire time.
My friend Colin and I have been wanting to collaborate on some flying exercises for a while, so I invited him to run the MōVI sticks today. We flew one long-ish flight, and it was a beautiful day, and the copter and gimbal performed well, as did the two of us! The footage below is unstabilized and uncorrected. The only edits are a couple of the pans are slowed 60P-24P.
This is my custom X8 Octocopter with KDE 4012 motors, Mikrokopter electronics, and powered by dual Tattu 10000 mAh 6S LiPos. Panasonic GH4 with Olympus 12/2.0 and B+W 0.9x ND filter is flying on my Freefly Systems MōVI M5. Video downlink is RMRC 1.3gHz.
Thanks to Colin for the photos!
After months of R&D, I’m proud to show off the new PerspectivAIR copter. Unlike others, I have not given her a name. But she’s a stout bird, capable of lifting any of the camera/lens packages that I own. She’s got a Freefly Systems MōVI M5, the state of the art in camera stabilization technology on board. She’s also received a serious power upgrade so she can lift a large payload without breaking a sweat. I’ll continue to refine her electronics and structural systems to keep her at the leading edge of what’s available in this field.